PIC16F628A-I/P【PDF 16/180 页】IC MCU FLASH 2KX14 EEPROM 18DIP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3875

12页 13页 14页 15页 [16页]17页 18页 19页 20页

PIC16F627A/628A/648A

DS40044G-page 112

2009 Microchip Technology Inc.

FIGURE 14-16:

WATCHDOG TIMER BLOCK DIAGRAM

TABLE 14-9:

SUMMARY OF WATCHDOG TIMER REGISTERS

14.8

Power-Down Mode (Sleep)

The Power-down mode is entered by executing a

SLEEP

instruction.

If enabled, the Watchdog Timer will be cleared but

keeps running, the PD bit in the Status register is

cleared, the TO bit is set, and the oscillator driver is

turned off. The I/O ports maintain the status they had,

before SLEEP was executed (driving high, low or high-

impedance).

For lowest current consumption in this mode, all I/O

pins should be either at VDD or VSS with no external

circuitry drawing current from the I/O pin and the

comparators, and VREF should be disabled. I/O pins

that are high-impedance inputs should be pulled high

or low externally to avoid switching currents caused by

floating inputs. The T0CKI input should also be at VDD

or VSS for lowest current consumption. The

contribution from on chip pull-ups on PORTB should be

considered.

The MCLR pin must be at a logic high level (VIHMC).

Address

Name

Bit 7

Bit 6

Bit 5

Bit 4

Bit 3

Bit 2

Bit 1

Bit 0

Value on

POR Reset

Value on

all other

Resets

2007h

CONFIG

LVP

BOREN MCLRE FOSC2 PWRTE

WDTE

FOSC1

FOSC0 uuuu uuuu uuuu uuuu

81h, 181h

OPTION

RBPU INTEDG

T0CS

T0SE

PSA

PS2

PS1

PS0

1111 1111 1111 1111

Legend: x

= unknown, u = unchanged, - = unimplemented read as ‘0’, q = value depends upon condition.

Note:

Shaded cells are not used by the Watchdog Timer.

(Figure 6-1)

Note:

T0SE, T0CS, PSA, PS0-PS2 are bits in the OPTION register.

From TMR0 Clock Source

Watchdog

Timer

WDT

Enable Bit

8 to 1 MUX

PS<2:0>

To TMR0

(Figure 6-1)

PSA

WDT

Time-out

PSA

MUX

WDT Postscaler/

TMR0 Prescaler

Note:

It should be noted that a Reset generated

by a WDT time-out does not drive MCLR

pin low.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式